FlashForge Finder/Inventor II side window
Description
Simple side window for finder and invernto II. Drawn as one piece and then split in four parts in FlashPrint. I included the gx files I used to print ready splitted as well. Just print, glue together and it should fit. I used SAN plastic window cut to 253 x 207 mm to fill the frame. Just add some glue around the inner edge and press down the window. There are no designed way to fastened this. What I did was to drill a small hole in the middle of the lower and upper inner edge. A small wood screw with a washer from the inside hold the window firmly in place without affecting the printer in any way. Some double sided tape would probably work just as well but would leave a mark.
Statistics
Likes
5
Downloads
0