A10M Parts Fan Ring Duct
Description
I decided to design my own parts cooling duct as I couldn't find the one I liked. Fits a little snug in the fan opening, I just sanded the corners or trimmed with a razor knife till it slid in. I also used a 1.75 mm hex driver to ream the 2mm holes in the duct. When doing so take note as to which holes and at which angle your holding it, as to not distort direction of air flow (Holes positiond 45,horziontal,vertical are at a 67.5 degree) (Holes positioned between those locations are at a 45 degree) v1.2 Holes are at a 67.5 degree angle v1.3 Holes are at a 67.5 and 45 I printed at .16 layer height. use 8 top and bottom layers Might fit other printers alike Gimme a shout out if you like it and it works for you. Dont forget to post a make, Thank you
Statistics
Likes
14
Downloads
0