External Mosfet holder for DIN Rail
Description
This holder was designed for external mosfets with the hole dimensions 52 x 42mm like featured on the pictures. The dimensions fit the outer measurements from the mosfet itself (63 x 50mm) and don´t waste any space except a little extra height for extra cooling also from underneath. Like you can see it mounts on the standardised electronic top-hat rail (DIN EN 60715:2001-09). Model 1: 2 Clips on the Back (Supports needed) Model 2: 1 sided Clip on the Back (no Supports needed) There are no supports needed except fort he clip on the back. Printing Settings: Line widht: 0.4mm Walls: 3 This Part was designed to use a 0.4mm line widht and 3 perimeters / walls for a optimal result !!! With other values it will print too, but there might be extra infill lines and moves in between that can increase print time in comparison to the optimal values. Of course this is not relevant for every last corner oft he print but it´s worth mentioning ;)
Statistics
Likes
5
Downloads
0