Raspberry Pi Xilinx programmer case
Description
A case for Raspberry Pi used as a Xilinx CPLD/FPGA programmer. Room inside for a couple of 5V regulators (model airplane SBEC) and an extra opening in the rear for a 5mm power plug glued in place. Use one regulator(SBEC) (or USB) to power the Pi and a separate regulator to power the board being programmed. If you use the same regulator (or USB) the Pi will probably reboot when the CPLD device is connected because of a surge in current. The slim opening on the side is for routing the programming wires out. Guide for wiring the programming cable to the GPIO and programming with Raspberry Pi: https://github.com/terriblefire/tf530/wiki/Flashing-the-CPLDs-with-a-Raspberry-Pi
Statistics
Likes
0
Downloads
0