2040 End Cap Handle
Description
When I got the little Kingroon Kp3 printer, there wasn't a real good place to grab hold of to move it about. The spot most folks likely grab is the extruded Z-Axis location. This is alright (as long as you don't hulk out on it and thrash it around from that spot..), but I would often accidentally grab the z-rod as well. That was getting old, and I was also concerned with bending the rod. So, this was my creation. I have taps and dyes to thread the aluminum, so I went ahead and did just that for M5 bolts. I plan on making another version of this mount, where you can use M5 bolts with t-nuts for folks who don't have a tap and dye set.
Statistics
Likes
20
Downloads
0