Ender 3/E3 Pro Cable Chain and All Attachments (Single Print)
Description
I spent a while arranging all the links and attachments needed to print the full Ender 3/Ender 3 Pro cable chain from johnniewhiskey and I figured others could use it to save some time. I scaled down the smaller part of the clip by 2% because I felt it was too loose. Other than that, everything is copied and pasted from his work. Print a complete link and test your settings before printing the whole set. This print took about 23 hours with the following settings. Some people say that using a raft makes these parts easier to print, but I didn't need them. My cura settings: Creality PLA Layer Height: .16 Wall Thickness: 1.2 Infill: 80% Temperature: 200C End, 60C Bed Speed: 20mm/s base layer, 40mm/s for the rest No support No raft
Statistics
Likes
85
Downloads
0