Raspberry Pi Camera case with mounting holes
Description
There Are A Lot Of Camera Covers For The Pi Camera But I Needed One That I Could Mount Using Simple M3 Bolts. I Could Not Find Any So I Made One. The Tolerances Of The Parts Are Set So That If You Print It On Reasonably Fine Settings It Should Snap Together Without Any Major Post Processing. I Tried A Few Others And They Were Almost Impossible To Snap Together Since The Tolerances Were To Tight. Updates: 2014-11-07 V1 2014-11-09 V2 Distance Between Both Horizontal And Vertical Mounting Holes Changed To 30 Mm. Fixed That The Front Part Was Not A True Solid. 2014-11-10 I Have Made A Mounting Fixture That Uses The Holes On The Rim Of The Case To Attach A Swing Arm. The Fixture Makes It Possible To Mount The Camera At Any Angle. The Mount Is Found Here: Http://Www.Thingiverse.Com/Thing:536828
Statistics
Likes
30
Downloads
0