PhotonS Low Profile Venting Base
Description
This is a remix of the otherwise AWESOME Anycubic Photon & PhotonS De-Stinky-Nator (aka Airfilter) by IdefixRC. I already have a ventilation system installed for my airbrush spray booth, so I decided to mod the base to accept a 55x110 rectangular conduit (later decided to go for 100 round flex, so I made an adapter) and added adjustable feet. The top of the base has a shallow groove for a seal, in which I glued some bicycle vent hose (not sure if that is the correct term in English) which is basically 3.5mm round soft silicone hose. If you can't find that, a raised bead of silicone caulk would do as well. Just make sure the bead hardens before you put the printer on top. This should form a pretty good seal between the base and the printer. The leveling... When the base was done to my liking I put the printer on top and installed the resin vat. Then filled the resin vat just to the height of the inner bevel with water with a tiny drop of washing up liquid soap added to break the surface tension. Then levelled the printer -vat- by adjusting the screwlegs until I was satisfied. HAPPY SUCKING!
Statistics
Likes
21
Downloads
0