Elegoo Mars Drawer Base w/front USB
Description
Remixed to add a front USB to be used with a USB extension cable. Also adjusted to not require support attached to the print bed after I had a failure. To be printed with drawer openings facing the top. Cable used: https://www.amazon.com/dp/B00N9HRTFU/ The USB fit may be just a touch loose. Mine was just snug enough to hold the extension in place when removing the flash drive. Edit 12/19/19: Added appropriately-sized drawers (185x170x29) with finger cutouts rather than drawer pulls again to avoid support. Edit 3/25/20: Added alternative with 1cm taller openings to accommodate height of spare vats with lids and FEP-protecting bases. Added taller drawers to match
Statistics
Likes
96
Downloads
0