Liebherr Gefrierfach Lagerbock Halter Tür
Description
A simple replacement part to hold the freezer-door in place. I had to re-drill the hole in which the door pin is held with a 9mm drill, because it's a bit too small and you just want a clean surface for the rotating pin. Printed on the side with the hole for the screw, you'll need support (only touching surface) for that, but it snapped off super easy and this is the side that's facing the fridge anyways, so never seen. Printed with Infill 50% and default settings for Ender 3 Pro PLA in Cura. Fits absolutely perfect!
Statistics
Likes
1
Downloads
0