Dual Z Belt tensioner (6mm or 10mm) Belt
Description
Could not find a fitting Belt for my dual Z mod so i had to have a tensioner for it. For the dual Z mod of my Ender 3 Pro i uses a 6mm 784mm Belt and 36Teeth 8mm bore (6mm Belt) gears a i wanted to use a closed belt. using a 10mm belt should not be a problem as the Belt runs in the middle of the 3 bearings so there is enouth room. For this to work as i used it you will have to lift up both gears 5mm. I used 1 bearing (the same used in the original mod) for each gear. And then used 3 bearings as the tensioner wheel . Also added my fusion360 files if someone needs them :)
Statistics
Likes
44
Downloads
0