Foot for small DIY Leveling table for casting
Description
When pouring small flat silicone rubber mats that are used for assembling electronics, its important to have a level surface to set the casting container on top of. This project designed "feet" for a small leveling table. It uses 4 leveling feet, washers, coupling nuts, springs and a flat piece of wood or Plexiglas. 1) Hot Glue 4 Elevating bolts to a flat piece of wood 2) Put a small tension spring on the threaded portion of each 3) Put a washer on top of the spring 4) Thread the coupling nut with the 3D printed foot on the elevating bolt 5) Turn it over and use a spririt level to level the surface for both front-back and left-right 6) Looking down on the surface, turning the foot clockwise - RAISES the corner.
Statistics
Likes
2
Downloads
0