Z Axis Switch Trigger Arm (for M3D's Crane also Fits Creality)
Description
This was made to trigger the Z Switch in order to Manual Micro step/trigger the Z Switch, rather than moving the Z Switch around...now you can use the dial. Turn Clock wise for bigger gap and counter clockwise for smaller gap. Uses 1 -20mm 3M Screw and 2 - 3M nuts (one inserts into the mount for the screw...the other locks the screw into the dial knob. A spring isn't needed but may help keep tension. Clips right onto the gantry arm. Printed with 3 walls, 50% infill for strength. Screws/Nuts https://www.amazon.com/gp/product/B075QKQGTD From Chris Gizzi : "If you divide into 10 slices (36 degrees ea) your increments should be 0.1 mm each. Again this assumes metric screws with a 1mm pitch. (1mm per rotation )" This is if you decide to print the MMU Dial...which will allow your you better Dial in your steps.
Statistics
Likes
0
Downloads
0