Strap Winder Drill Bit (1 inch straps)
Description
This is a simple drill bit for winding up 1" straps. Simply put the bit into a hand drill and tighten it, then slip a few inches of the end of the strap through the gap and start winding it up. Start slowly and use the other hand to guide the strap to keep it aligned. Then just slide the rolled up strap off of the tool and put some velcro around it. Print vertically with a brim to keep it attached to the build plate. No supports are needed. Use thick walls to give it strength. Enjoy! -Alterius
Statistics
Likes
13
Downloads
0