Ruixin Pro Sharpener - Upgrades
Description
This is a Scissors, Chisel, Magnetic Large blade, Small blade and other tool sharpening attachment for the Ruixin Pro Sharpening system (Metal Version). It is combined with a flat ground knife magnetic table and 3-position guide system with numerous attachments. See pictures. I also have 2 versions of my Fine Tuning adapters. One is for a 7mm vertical rod, and one is for a 8mm vertical rod. This allows you to sharpen and adjust your angle with micro adjustment for that perfect edge. I highly recommend a strip of rubberized tape (I use ISC Racers Tape) for the insides of the clamps for a very secure grip. Scissors Clamp - Use M4 brass threaded melt-in inserts for the 2 holes in the platform side of scissors clamp, and 1 x M4 brass threaded melt-in insert into the larger bottom hole of the scissors clamp. 3 x M4 screws of the correct length are also needed. See Photos. Also use a brass insert in the small centre hole of the table platform, and use 3 Neodymium magnets forced and epoxy glued into the 3 recess holes. Magnet size 12mmx3mm round. If you want to use the Large Blade attachment, you will 6 more 12mmx3mm round neodymium magnets to install in the 6 holes of the Large blade attachment. Chisel Sharpening attachment - Install 2 x M4 Brass inserts into the 2 angled top holes of the large part of the chisel adapter. Simply remove the current adjustable knife guide from your Ruixin pro table, and replace it with the platform for the scissors sharpener. Screw into position with a nut of the right size on the bottom and tighten. The clamp part of the scissors attachment can be used as follows: (See my photos) Note - The bottom hole is for counter-tightening the clamp as described below. Tighten the top 2 screws onto your scissor blade to be sharpened, and then tighten the bottom screw if desired (The bottom screw should only have a brass insert on the inside of the small clamp, so it basically then opens the bottom of the clamp up when you tighten the bottom screw, effectively forcing the top closed even tighter on your scissors blade. The top two screws are for lightly holding the scissors blade in place and positioning it, after which you tighten the bottom screw which then opens the bottom of the jaws, forcing the top to grip the scissors blade tightly. Brass Threaded Inserts Example: https://www.amazon.com/dp/B07MWBJB67/ref=cm_sw_em_r_mt_dp_U_Ho0bEbPPA9P23 If you find my designs useful, please go ahead and click on "Tip Designer" to the right of the photos at the top of this page. Proceeds will be used to purchase printing filament so I can keep designing and testing cool new things that you might find useful. Thank you! UPDATES: 7 January 2021 - Added the large blade attachment and the Chisel attachment. 24 January 2021 - File updates with some design changes. 31 March 2021 - Updated the Fine tuning adapters for easier printing. NOTE: Some of my other useful designs: https://www.thingiverse.com/leadingedge/designs
Statistics
Likes
22
Downloads
0