Wanhao I3 Hotend LED strip
Description
Created this to light the hotend directly after changing to a backside cooler on my Wanhao. This doesn't exactly light the nozzle, but it is a huge improvement. It's a quick print, one screw, and "hangs" on the OEM cooler mount. This is designed to be clear of an EZABL bed leveler system, so anything with a mount on that side is clear. I may have slightly undersized the screw hole, as it is a bit tight, but that is a benefit in my mind. Should fit a single "section" of LED strip. I printed the original design, which was a bit short, but decided I didn't care to reprint to have all 3 LED's in the right place personally. 2 did the job. Using the 95 CRI LED strips like DIYPerks on YouTube recommends for his LED panels. 5500K is a very real daylight. And what I use for the entire enclosure. (Helps with time lapses, and not using PWM means NO sync issues on Octoprint/Octolapse.
Statistics
Likes
0
Downloads
0