Anycubic Kossel V5/V6 Super-Light Effector Combo w/BLTouch
Description
I ended up overhauling this entire project, as I finally found a setup that doesn't require jamming a fan into the heatsink. This is the lightest setup by far, and I included the f3d files to help with modifying it as needed.The E3D V6 just requires the V6 specific effector, but the V5 heatsink will work with @jonez7 hot end adapter, although it may not be needed (https://www.thingiverse.com/thing:2449797) You can use your stock hardware, but you will no longer need the spacers for the effector. I'm also still using the stock cooling fan with an updated duct ( https://www.thingiverse.com/thing:2671635 ). I wish I saved the photos of the weights, but for reference - the stock metal effector was touching triple digits, while the ABS one was around 20g. That in itself is massive. Your nozzle-to-probe offsets should be as follows: M851 X28.05 Y-12.32 Z -2.91 Don't mind the piss-poor printed parts, those were off of my Chiron that I was testing new settings on. You can still use the stock leveling probe, but this was optimized for a BLTouch. Best when used in conjunction with the center-fixed extruder: https://www.thingiverse.com/thing:4224228
Statistics
Likes
36
Downloads
0