Crinkle Lamp Customizable Spotlight LED Base
Description
The included file is for a 100x100 inside diameter lamp Use the F360 file to enter your own parameters (Change parameters) I included a lot of settings to adjust **Parameters** LED_Hole: Enter the radius of the non flanged area of the LED, Make sure to keep the springs in mind when measuring LED_Top: The flang radius on the top of the LED Cover_Raise: The visible height of the base, if you increase it you can get the led to be flush with the bottom of the cover but I like mine unevenly lit Spacer_Length: how much to raise the led. make it at least as tall as your LED and add a bit of a room if you want for the heat, set to zero to use your own metal (the printed ones are a little fragile but it's not like you're gonna punch them once you put it together) Diffuser_Height(Optional): if you want to use a diffuser (I didn't. I like mine to be unevenly lit again to create shades) you can enter the height of it here, if your led is very big you probably can't use this without modfying since the shapes poke inside so you have little space to work with. Cover_Wall_Thickness: enter the thickness of your cover to make it flush (I recmmend using the 4 squares on each corner! Cover_Height(Length): Accidentally put Height in there. woops... Measure the inside of your cover with klippers and enter it with a 0.2mm~ to 0.5mm~ reduction depending on how accurate your printer is Cover_Width: Same as above, Incase it's not a square for you.
Statistics
Likes
6
Downloads
0