Trampa Concave Pads
Description
Trampa concave pads, suitable for all trampa decks (and if creative also for other decks). These pads can completely replace your bindings for a street setup build for example. I recommend using the pads in combination with bindings, it will decrease foot fatique and give you more control over the board. The pad is 22 cm long and approximately 5cm wide. This will make sure the pads will not interfere with most top mount battery boxes and the binding mounting holes. The pad can be used for both the left and right side of the deck. They can be attached usin epoxy (like in the example images) or strong dubble sided tape (3M VHB tape). Pads should be printed in TPE or a harder TPU. Ninjaflex could work but is a bit too soft for my taste. Ninjatek Cheetah works nicely. However, I recently also tried the hobbyking flexible filament which is perfect for the price. https://hobbyking.com/nl_nl/flexible-3d-printer-filament-black.html I printed them at 0.1500 layer height, 50% infill, 5 perimeters, 3 bottom layers. Feel free to donate :)
Statistics
Likes
8
Downloads
0