Model Rocket HR&T
Description
A rocket made in tinker-cad its large and everything fits well. You may have to use wrap tape around the nose cone for a tighter fit for pressure reasons. This rocket is heavy so you might have to use B and c motors. A does not go high enough to deploy Parachute. This should take about 8 hours to print it is re usable.Just glue on fins and the hole on the side is optional for a paper clip to go in and bend down and hold the rocket but the motor most of the time stays in due to the pressure so you can tape the hole or don't it doesn't effect it. Line up and glue the rings on the rocket (I used hot glue) the extra one on the side is not necessary it's just there (idk). If you have ever done a Estes model you should know how to put it together if not very hard just watch a video. All you need is a parachute,medium length rubber band,glue gun, and a piece of paper. For Flying it you need a B motor,starter,plug,launch pad and remote launcher. Pleas give your comments and feedback if there are any issues and I will use them to make a better MK2. Have good flights and I will be uploading a video and pictures in the near future. Have fun!
Statistics
Likes
0
Downloads
0