Kingston FCR-SH4 card reader holder
Description
I advise printing it standing to maximize layer strength, rotated 45 degrees to get even cooling for a nice finish (as is the file right now), with a 5mm brim. There are 3 Versions, each version is a bit wider than the last as V1 was a bit too tight. Each consecutive version is wider by 0.3mm. I was satisfied with V1 but I made versions for people to choose at their own discretion. Some post process may be required to round off any drooping may occur. Should you wish to make modifications, and need it aligned to an axis, rotate -45 degrees. https://www.reddit.com/r/3Dprinting/comments/ehknck/am_somewhat_proud_of_this_one_card_reader_mount/ If you find this useful or entertaining enough, tips are welcome. :)
Statistics
Likes
15
Downloads
0