MKS Gen L Board holder dual fan enclosure
Description
This is a Remix of TeachingTech's amazing design but then with a dual fan and made for mounting under a table. To use this design you probably need to extend some of the wiring of the printer. My set up is with two 5V 40x40 silent fans. I made the box a little higher so you have more room for all the cables and air flow is better around the stepper drivers. p.s. my photo's were made when cables were not decently attached yet ;) With the current set up I can print ABS with good quality and not worry about the elctronics getting to hot. Hope you like it. Enjoy printing and be carefull if you play with the electronics!
Statistics
Likes
2
Downloads
0