Sapphire Pro extruder relocation and cable management kit
Description
Extruder bracket + cable management solution. Same stock gooseneck fitting as here: https://www.thingiverse.com/thing:4082872 Designed to be mounted without disconnecting any wires! You can use it on stock location but I've created it for my printer to relocate extruder from rear wall to side. This allows better printer placement on the bench (NB! Please mind cooling fan grill) Bracket uses thin M4 nuts pressed onto hex slots (you would need min 2 pcs, no nead to use more than 4 pcs). Please check pics to compare thin and normal nuts. Normal nut will fit too, but depth is optimized for thin ones. Bracket itself is mounted to 2020 profile using exactly same nuts which currently hold your BMG extruder. Two M4 DIN 7991 Hexagon socket countersunk head cap screws needed. I've glued all parts together with epoxy resin, pls use any glue that fits your plastic. Bracket plug is optional. ------------------------------------------------------------- ------------------Optional ------------------------------- ------------------------------------------------------------- NB! In case you printer has an original acrilyc case or very neat cabeling is desired, few cable management issues may be met. Check, if there are any comfortable 2020 extrusion slots availible for placing yout wires. Mind screws holding 2020 extrusions to bottom case. I found most convinient way to lay my wires by cuttind a small slot in extrusion under the hood. I've drilled 3 holes diagonally and filed a piece out. See last pics. Ensure there is no sharp edges.
Statistics
Likes
15
Downloads
0