Magpul USGI follower copy w/ 458 socom follower
Description
Modeled these after a Magpul USGI model. Don't sell these on eBay fam, but make some for your buddy at cost. Spread these bad bois far and wide. Throw em on the github too bby. I would suggest PETG for this because of the weather resistance it provides or other filaments that can survive hot weather. You'll need to buy a bottle of dry lube and spray it on the inside of your mag to get it all slippery like so it doesn't cause any issues. Blaster, 3 IN ONE, WD40 etc should all work fine, just spray it on the inside of the mag where the follower rubs against and you should be all fine. AGLeaks is a moron and a big big baby
Statistics
Likes
13
Downloads
0