Bigtreetech Smart Filament Detection Module Mount CR10 / Ender 3
Description
This is a remix of the original part from bigtreetech https://github.com/bigtreetech/smart-filament-detection-module/tree/master/STL. The electronic is taken from the original sensor housing. After installation check if filament runout distance is set, otherwise the printer will stop immediately after start printig. Mine was 0mm after updating firmware M412 D7 sets the lengt to 7mm: M412 echo:Filament runout ON Filament runout distance (mm): 7.00
Statistics
Likes
53
Downloads
0