Da Vinci AiO Calibration Target
Description
I recently picked up a Da Vinci AiO for parts and got it working again. I had to switch it over to Repetier to get passed the latest firmware, but it prints and is pretty good to go. I was following a github on incorporating Horus scanning software with the AiO. I made this to better simulate the AiO's actual calibration target. I almost got it to calibrate this morning, but the slider moved and the colored lines vanished. I'd welcome any input for help calibrating the software. I know not a lot of people have AiO's, but surely the Ciclops scanner has the same sensitivity issues. I think the software would function if I can just get passed the set-up. I designed the parts to slip fit together and I printed my target on cardstock that I just folded in half to slide into the gap. You need to print two of the screen parts and one each of the base and calibration. EDIT: 5/3/2020 I've abandoned trying to get the scanner working. There's no support for the Ciclops and Repetier gets confused with the printer being a printer and a camera. It's taken a while to get it all running right, so for now I'm content with it just being a printer.
Statistics
Likes
5
Downloads
0