Runcam Nano 3 mount for Toothpicks and Whoops
Description
If you like my work please consider following/subscribing to my feeds : [Instagram](https://www.instagram.com/ledrone.club/) and [YouTube](https://www.youtube.com/c/ledroneclub) Or you can [support me via ko-fi](https://ko-fi.com/ledroneclub) ----- Some simple mounts for the Runcam nano 3 fpv camera made primarily for whoops and Toothpicks. #### Toothpick version A simple pod "a la" newbeedrone. The dimensions are adjusted to the Nano3 and have 2 ears that can be used to fit a Mini MortalT crossfire antenna or used to ziptie other kinds of antennas. if you prefer. The camera should be secured with 2 tiny whoop plastic screws from the rear (the super tiny ones usually provided with whoop boards). The camera angle is 30 or 40 degrees. The holes that attach to the stack are 1.8mm intended for press fit (no need for nuts). You can get a greater angle by elevating the front attach a bit (use a nylon nut to hold the FC for ex.) #### Whoop version This one is a bit experimental and doesn't work so well in fact. It's a flat design that is meant to be folded at installation. This provides structural tension and makes it work. It should be fine for whoops only but a bit too soft for toothpicks or heavier setups. The angle could be adjusted by turning the side tabs front to back.
Statistics
Likes
59
Downloads
0