RC navigation lights (incl. f360 file)
Description
I made some navigation lights for small rc boats/ships. Dimensions: Height: 14.5mm Width: 6.5mm (without led house) Width2: 10.5mm (with led house) Length: 33.5mm you can install a 3mm led from the top/side. There is a small hole where the bottom of the led will fit the leads will come out through a small hole on the bottom. You can then glue them in with something like epoxy or any other glue that works with pla. The lense is quite thin so don't break them :) the lense is also glued in. For the navigation housing you will need to use support EVERYWHERE. Use low density for support to make them better to remove. I found out that using 0.2mm layer height was the best way to print the housing. when trying to print them with 0.12 or 0.16 while removing the support they always broke apart. With 0.2mm they were more robust.
Statistics
Likes
10
Downloads
0