Thrustmaster T300 T500 wheel mount centre repair
Description
UPDATED, first test fit - it seems the Square shaft hole, is a little tight. It should measure 28mm, but the print will likely ooze enough to mess up dimensions. I will upload a modified file (v14) which should give better tolerance. T300 and T500 centre mount for wheel. Not fully fit tested (fits wheel ok, but unable to test fit on main metal shaft of base unit due to presence of wires. This was designed to attempt a repair on a wheel base with damage to this part and the flanges of the electrical connector. Hope it helps someone out maybe?! Printed in ABS, but PLA should work ok. I have concerns around the strength of a printed part here, any tests/success would be good to hear about.
Statistics
Likes
7
Downloads
0