CR-10 FANG W/ BLtouch (Micro Swiss Direct Drive)
Description
*EDIT 2/18/2020* Added wire guide to support clip (v3) If you have already printed this you can either drill a 3mm hole in the original base or just leave it. Seems stable enough without the extra screw ------------------------------------------------------------------- Fang mount for Micro Swiss Direct Drive This base is for the micro swiss hot end You will need to print the fan and 40mm fan duct from https://www.thingiverse.com/thing:2763931 I ended up needing t m3 nuts as spacers for the bltouch. I added a washer for good measure. All in all it is performing well x_offset: -40 y_offset: -10
Statistics
Likes
60
Downloads
0