Bed Level Correction Assistant
Description
#Make bed level correction easier and quicker! ----- ##Optimized for Original Prusa printers. ----- ##(Mostly)Parametric Fusion 360 design file included ----- ###Procedure: (Assuming you cleared EEPROM and have to start over) - Run XYZ Calibration - Meanwhile slice all 4 STLs with your general settings - Run First Layer Calibration to achieve basic adhesion - Print **Live Z.stl**, observe bottom face and adjust Live Z, repeat until desirable bottom surface finish is achieved - Repeat with **Front_Back.stl**, please note L shaped indicator points to the *front* of the machine, adjust Bed Level Correction. - Repeat with **Left_Right.stl**, this time indicator is on the *left* side and is also pointing to the front. - Finally print **Whole Bed.stl** to confirm and compare all bottom finish of all squares.
Statistics
Likes
2
Downloads
0