Headphone stand for top of pole
Description
A headphone stand designed to slot on top of a pole. The pole of my VESA monitor stand is 32mm, but you can always use a layer of duct tape to make it fit slightly smaller poles, or scale the thing down. The distance between the round section and the end of the headphone holder is 35mm, so your headphone's headband width should be less than that. I recommend using a denser or more supportive support, such as grid. The zigzag pattern in Cura could not fully support the model, so it ended up looking bad where the headphones sit. I tried again with grid and it worked just fine.
Statistics
Likes
3
Downloads
0