IKEA Skadis Peg board snap fit connector (V2 Updated)
Description
Hi, I needed to hang one IKEA Skadis under another and decided to design this snap-fit connector. Print without any support. In order to install it put two IKEA Scadis pegboards on the floor, take the longer connector part and put it underneath peg-boards. Then slowly apply pressure until it fit into the board. Then close it from another side with a second connector piece. The connection is pretty tight so might want to use a mallet or a piece of wood to close two parts together. Be careful while moving the boards until you install all the connectors because 2-3 connectors will not sustain the weight of the boards and might break. Leave a comment if you have a question or suggestion. UPDATE 31.07.2020 I've uploaded a new file which is version two. It combines both male and female parts as suggested in the comments. I haven't printed it yet, but the model is the same, so it should work same way.
Statistics
Likes
33
Downloads
0