Floss v3.0
Description
Make your Floss V3.0 just a bit more protected from prop strikes. I made these parts right after a crash that resulted in my stack getting smashed up and my motor wires being snipped. Each wire protector is 2.5g and each side protector is 1.5g, so with everything it is an added 13 grams. Motor arm wire protectors should be cut in the middle to attach and then zip tied on. Print with the thick side up (this is the side on the top) and cut the bottom thinner side for attachment. Canopy V1 and V2 both work fine, I prefer V1 though.
Statistics
Likes
5
Downloads
0