Mini-T 2.0 Slipper Eliminator
Description
This is a slipper eliminator for the Losi Mini T 2.0, For those pros who don't need no stinkin slipper clutch. I found with mine that I had a LOT more power and punch as well as control after removing the slipper. Too much in some cases (over shooting jumps with a mamba motor on 3s). For this to work, you need to keep the slipper plate that is closest to the gearbox, remove both slipper pads from the stock spur gear, and mesh this piece into the hex pattern on the gear. There is a square relief on the underside that mates with the square protrusion on the gearbox side slipper plate. use the stock nut to tighten it all down but not too tight as I've noticed this will push the gear off center and create a wobble. print at 100% infill and pla should be fine. Most printers won't need support for bridging these short distances but you choose that to your liking. I prefer printing small stuff like this at fine resolution.
Statistics
Likes
13
Downloads
0