Tarantula pro squash feet
Description
The original squash feet come from dr Boo, all the credits for him. I remixed it so the Tevo Tarantula pro could stand on its own feet on the damping squash feet. The original was mounted on a cr10 frame. Now I've combined the damping of the original feet which is limited, with the damping of the squash feet which is huge. The printer is a lot more silent, and at least the first few prints are of a far better quality since the feet are installed. In the comments on drBoo 's squash feet someone mentioned they broke because of low grade of infill. I made an infill of 80% for the upper part where the TTP feet are in plus a bit of the cap for the squash ball. I used two dot squash balls, these are very easy to get on Aliexpress
Statistics
Likes
5
Downloads
0