Krytac trident PDW dropstock (deans suited)
Description
First off all i'm not responsible for any damages you make when using this design, use and install at your own risk. 2 main risks: - Make sure your cables fit into the trench and don't get stuck or squished which could cause electrical malfunction (Or worse). I do want to note that i have been using this dropstock fine in combination with the stock cables that come with the Gate Titan mosfet. For extra protection I wrapped electrical tape (1 thick) around the cables where it goes into the trench. - You'll need an extra bolt (and nut) and maybe another extra one if your sizes are off. Make sure the bolts do not extend too far into the body(bottom one) and in the top make sure it goes as far in as your original bolt. measuring is key. Okay so now down to the design. This design has 3 major differences from the original dropstock. 1. it will fit the m6 bolt that comes with PDW. 2. It has the space to fit a Deans through instead of only taminya. 3. The cables come out at the bottom instead of the top, this is essential for the PDW since otherwise you need to dremel/modify your whole stock. So to make it clear this design does not need any modifications on your original parts, it will only add stuff. Required: - 1x nut M6 - 2x bolt m6 (ill add my sizing later) I had to trim mine down a little for perfect fit. Reason for a dropstock is so i can use my rail as intended (rather then using a ton of risers to fit everything on, and still wear a WarQ helmet without being hampered aiming down sight.
Statistics
Likes
24
Downloads
0