Ender 5 LED strip holders
Description
A pair of holders for 30cm LED strips (10mm wide) One for the front with 10 degree angle down, and the one in the back has a 66 degree angle so it doesn´t shine straight in your face. They are both split in two parts which snap together with some glue. (Couldn´t fit them on the printbed) Mount with T-nuts and short M3 screws Print the front holders with support and the back without <B>Edit:</B> I noticed that my Front LED holder was getting a little bent, not being 100% straight in the joint. Therefore I made a small add-on. A third mount that fits perfectly in the center. IF this happens to you as well, there´s no need to re-print, just add this small piece ("xtraholder.stl")
Statistics
Likes
381
Downloads
0