3mm tube bender
Description
Here's a very small tube bender, designed for use on __3mm__ hollow brass tube. I needed this to fabricate a new choke tube for a Mikuni BT carburettor. Additional parts required: ---------------------------------- 2 x M5 x 25 bolts 2 x M5 nuts 4 x washers Instructions for use --------------------------- 1. Position the bender base and handle to roughly 90° and insert the tube between the two grooved forms. 2. Gently clamp the bender base and the tube in a vise, or just wrap some tape around the tube and base to hold them together 3. Rotate bender handle until the desired bend angle is formed. See photos for reference.
Statistics
Likes
79
Downloads
0