Mirrored Einsy Case for Prusa Mk3 (with heatsink window)
Description
I don't know why Einsy's box opens inside. This makes it very difficult to access the wires. I flipped the original box and tweaked it slightly to cover more at the bottom. I made an (optional) opening for the heat sinks behind the TMC drivers. *(The heat sinks are surprisingly hot to the touch.)* Really easier to use! --- Wire conduit version: https://www.thingiverse.com/thing:4169443 --- update 2020. 02. 08.: - I moved the cable connector so that heat sinks can be installed inside. - I put a vent in the top of the box above the TMC drivers. - There were more vents on the door. - An optional 30mm fan lock was installed on the door. (I connected a 12V fan to the 5V connector. See picture. Quiet, but it moves the air.) - I made a aligment helper for the rear heat sink. --- Original models by Prusa Research: https://www.prusa3d.com/prusa-i3-printable-parts/ --------------------------------------- [Blog](https://zen3d.hu/ "Zen3D 3D nyomtatás blog") [Instagram](https://www.instagram.com/Zen3Dlab/ "Zen3D on Instagram")
Statistics
Likes
24
Downloads
0