Glass Bed Corner brackets for Flashforge Creator Pro
Description
These Corner Pieces Are A Perfect Fit For The Flashforge Creator Pro Using The Glass Build Plate By 3Duniverse (Http://Shop3Duniverse.Com/Products/Glass-Build-Plate). There Are Two Different Brackets. Make Sure The Raised Tab Is On The Short Side Of The Build Plate. I Purchased Some Stainless 3Mm Wingnuts And Fender Washers To Secure The Bracket To The Build Plate. The Oversized Washer Helps Prevent The Nut From Melting Into The Abs Plastic When It Gets Hot, Which Causes The Bracket To Loosen Over Time. The Wingnuts Allow You To Tighten The Bracket On The Fly If They Do Loosen. . I'M Using This Shim To Adjust The Z-Axis: Http://Www.Thingiverse.Com/Thing:440022 Update: I Have Been Printing On This Glass Bed For About A Month Now. I Was Using Kapton Tape And Abs Slurry Previously, Which Worked Well But I Got Tired Of Air Bubbles And Replacing The Tape. For The Glass Bed I Have Found That Glue Stick Works Really Well. I Am Using The Elmers Purple "Disappearing" Extra Wide Glue Stick. I Make Two Passes With It, First Long Ways Then Short. I Have Found If I Get The Bed Leveled Real Well, And The Right Layer Of Glue Stick, I Can Do 30 Prints Without Having To Resurface, Which Is Nice. After A Print, I Need To Let The Bed Cool Down To About 50C Before I Can Remove The Part, And Then It Just Pops Off. If I Try To Take It Off Too Soon It Is Near Impossible. Also, I Am Running The Bed At 115C And Extruder At 230C. I Hope That Helps Anyone New Trying To Print Onto Glass.
Statistics
Likes
39
Downloads
0