Xbox Headset and Controller Wallmount
Description
Material: PLA or PETG Settings: At minimum, 3 walls with a 0.4mm nozzle diameter since this will be a loading bearing part Recommended minimum 15% infill however infill doesn't contribute too much to part strength Whatever speed your printer can handle Increase flow rate or line width if you want a stronger bond but reduced dimensional accuracy No supports, slice and print xbox logo face down. Keep in mind any imperfections on your printerbed will also cause defects in the final part. Assembly: Acyrlonitrile glue or wood glue on the xbox plate and secure to wall plate. Allow any physical glue like wood glue to dry atleast 24hrs before use. Use clamps. Acyrlonitrile glue only needs approx. 5min to dry before unclamping. Use 25lb loading bearing dry wall screws to mount the plate to a wall
Statistics
Likes
10
Downloads
0