m5x16mm cap bolt tested
Description
Printed at 0.12 and it fits a s/s M5 nut easily - maybe a little loosely. It uses the standard 4mm (for M5) hex key. If you want the bolt to be tighter try an outside thread diameter of 4.9 or 5mm (for really tight) see below for modification to customizer. Customized version of https://www.thingiverse.com/thing:193647 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=193647 The photo (if I can get it to load!) was the test I ran - just happened to have translucent red loaded. I used a brim, hence the mess, but it's not really needed for this size.
Statistics
Likes
1
Downloads
0