Remixed Pi Camera Mount
Description
**NOTE 1: I don't have a 2.0 Module, so this is tested for the 1.3 module only.** I only had a CAD model of a 2.0 module to try with Fusion360 if it fitted in the pegs, and it did, but again, I haven't personally tested it. I'd appreciate if someone with the 2.0 module could test it. I'd do any modification needed. **NOTE 2:** Put the anchor point in the opposite side of the ribbon cable slot or **the holes will not align**! --- A no fuss alternative camera holder for [pbroeder's arm mount](https://www.thingiverse.com/thing:3778486). Use it together with [TeachingTech's flexible webcam mount](https://www.thingiverse.com/thing:3223979). The fit of the original model by Modmike is so bad that I decided to make my own, but instead of using complicated fittings, snap-fits, sliding rails or other methods that require a precisely tuned printer... I just put 4 screw holes and that's it. Simple and clean. You'll need 2 or 4 **M3-0.5 screws**, depending on how secure do you want it to be. **6 to 8 mm long**. I used 16 mm long because that's what I have and I don't mind them protruding from the back. I might get the Dremel tool out and cut them at some point... **I've provided two anchor points, one in the back piece and one in the front piece:** You'll need a Back piece with the anchor point and a front without it. Or the back piece without anchor point and a front with it. Or, hell, print both anchor points. Who am I to stop you?! *** **Post some Makes if you print this!** **Like and comment if you ended up using this design!** Thank you han have fun. :)
Statistics
Likes
11
Downloads
0