Vase Mode Water Pipe for 100x12mm Chillum
Description
NOTE: I would only use a 3D Printed water pipe with a vape as the vapour is MUCH cooler than smoke. Use at your own risk. Material: Best printed in PETG for flexibility and heat resistance, but PLA also works fine. Nozzle size: 1mm Line Width: 1.2mm PRINT IN VASE MODE/SPIRALIZE OUTER CONTOUR. Takes about 2 hours at 30mm/s. YES it is watertight. Hole is sized for a 100x12mm chillum, which fits the Dynavap vaporizer tip. There is even a little cutout in the base (happy accident on my part) to keep the end from sliding too far back on the bottom and keeps the downstem at a 45 degree angle. [Here's what the bottom looks like on a glass bed!](https://i.imgur.com/kbS7Fxo.jpg)
Statistics
Likes
30
Downloads
0