Axial Capra rear light bar
Description
I wanted rear lights on my Capra, so modelled and printed this. It requires two 5mm red LEDS, and some m2 screws to hold the cover plate on. the wires can exit the bottom, and I cut a little slot in the rear of the faux fuel cell on the Capra for neat wiring. I did not glue my bar in place friction seems enough although a little glue could be used. I used 600 grit wet and dry to give my LEDs a matt finish and a less focused beam. I also used hot glue inside to hold LEDs, and wiring. I printed using one perimeter layer. Its not very heavy, and in my opinion looks great! especially if you have fitted headlights too! Capra is a very capable model and deserves some rear lights!
Statistics
Likes
16
Downloads
0