LED Holder for Printrbot Simple Metal
Description
I Wanted To Shed A Little More Light Onto My Printbed So That I Could See What Was Going On Better And Time Lapses Would Be Clearer Through Octoprint. It Will Work Just Fine Without The Cover Piece, But I Wanted The Cover To Hide The Wires And Led Leads. I Have Mine Setup With 2 3.3V Clear Leds Connected To A 2Xaa Battery Pack With A Switch ( Planning On Connecting Them To The Gpio Of The Raspberry Pi Running Octoprint Soon ) Depending On How Well Calibrated Your Printer Is You May Have To Drill Out The Led Holes Slightly. The Ridges On The Inside Of The Cover Piece Are Not Clips, They'Re Meant To Be Stops So That The Cover Doesn'T Get Pressed Too Far Over The Led Holder. Mine Friction Fit Together But I Added A Little Hot Glue To Secure The Cover In Place. It Friction Fit Onto The Printer Very Well And Doesn'T Seem To Move At All During A Print
Statistics
Likes
40
Downloads
0