JoMo's Ender 3 Rear Electronics Case - remix
Description
First design period, used TinkerCad since i can't figure out Fusion yet. Only took about 4 iterations to get bosses lined up and add the back to the cases. Hope you enjoy, case feels much more sturdy than the original teaching tech case. I cut out a hole on the right side lid to access the reset button on the e3 for quick resets if needed. Also added another screw so that the lid is secured twice and keep it from shifting around. I am stepping down the 24v to 12v and feeding into the distribution blocks, then using those blocks to power the new fans I'm using. Suggestions, Feedback welcome!
Statistics
Likes
30
Downloads
0