Modules with better alignment and lips for netpot
Description
02/11/2020: added a base module with 4 M5 screw holes. I just screw this module on a bucket lid, or even a wooden base on top of the bucket. 02/10/2020: added a resevoir module with a 3/4" BSP thread to attach a quick hose connector for easy maintenance or modification of the whole tower First of all all credits to Archipelagourbanfarms, with his desing.(https://www.thingiverse.com/thing:2403922) I liked this desing soo much (and i printed it ofc). But i'm a damn perfectionist and seeing that the top was slightly off center with a step, it was bothering me. So, i redesigned the module adding from 1 to 3 slots, even with a lip to hold the net cup once the plant/s is/are quite big (as seen here: https://www.thingiverse.com/make:450646). Note: if you plan to print the modules with the lips, you should print them upside down, just to avoid any support. hope you like them, good luck!
Statistics
Likes
56
Downloads
0