DIN CASE FOR SONOFF BASIC R2
Description
DIN CASE FOR SONOFF BASIC R2 Width = 1.5 module (1 circuit breaker = 1 module) Content to print: - 1 box - 1 cover - 1 spring clip - 1 pusher - 2 cable clamps Use : - The push button on the front panel activates the card button (on / off). - A hole in the front allows you to see the LED Assembly, integration into the board: - Place the spring clip in its housing (respect the direction of the profile in relation to the din rail) - Cut the front tab print support at the bottom of the case (see photo) - Insert the pusher into its hole and turn it until it slides without friction - Clip the Sonoff card under the rear tabs, then the front tab - Wire the terminal blocks, tighten the cable clamps - Screw on the cover (3 countersunk head screws M2.5-12) - Place the box on the din rail and block the spring clip IF YOU LIKE THIS OBJECT, PLEASE LEAVE A LIKE, A COMMENT OR A MAKE.
Statistics
Likes
73
Downloads
0